Would the state of stress at this critical point be multiaxial or uniaxial? Why? – Get an Orginal Paper (homeworkcorp.com/order)

1. A disk-type flywheel, to be used in a punch press application with 0.04, is to be cut from a 1.50-inch-thick steel plate. The flywheel disk must have a central hole of 1.0-inch radius, and its mass moment of inertial must be 50 in-lb-sec2 .

a. What would be the maximum stress in the disk at 3600 rpm?

b. Where would this stress occur in the disk?

c. Would the state of stress at this critical point be multiaxial or uniaxial? Why?

d. Would low-carbon steel with a yield strength of 40,000 psi be an acceptable material for this application?

find the cost of your paper

Place New Order
It's Free, Fast & Safe

"Looking for a Similar Assignment? Order now and Get a Discount!

Scroll to Top